|
RAPID SET FLOOR TILE ADHESIVE
 SPECIFICATION CATEGORY:
Conforms to BS 5980
Type 1 Class AA requirements
DESCRIPTION:
Specially formulated
for the rapid fixing of porcelain, slate, marble, limestone, mosaics and
natural stone tiles, internally and externally.
Its rapid setting
capability allows for light foot traffic after 3 hours. Adding Flexmaster admix will increase flexibility,
durability and adhesion strength.
ADVANTAGES:
* Fast setting formula
* Walk on and Grout after 3 hours * Thin and thick bed adhesive * Interior and exterior use.
USES:
For fixing porcelain, slate, limestone, marble, mosaics
and natural stone tiles. Used primarily
for tiling onto concrete. and in areas subject to prolonged wet conditions and
condensation, and is unaffected by frost after setting. When mixed with Flexmaster admix will fix
tiles to a wider range of substrates. Please
refer to our “Tile to Substrate “guide or call our 24 hr helpline on 01257
269243.
APPLICATION:
Only mix small quantities at a time until you have become
accustomed to the fast setting nature of the product. Always mix powder to water and mix to a
buttery consistency, never add water after initial mixing, as this will impair
the strength of the adhesive. As an
approximate guide for powder to water ratio, 20K of powder requires
approximately 5L of water.
THIN
BED
On flat, even substrate where dry conditions exist, apply
adhesive to substrate as a thin floated coat at a uniform thickness of 3mm and
then rib using a notched trowel or spreader.
Bed tiles into adhesive using a twisting action, ensuring full coverage
of adhesive between tile and substrate. Where
tiling is subject to frequent wet conditions such as in showers, in addition, apply
as a solid bed a thin layer of adhesive to the back of the tile before applying
to the substrate.
THICK
BED
Where substrate conditions do not allow thin bed fixing, adhesive
should be applied to substrate as a floated coat 3mm to 6mm in thickness or
locally up to 12mm in thickness. Ensure
there are no hollow spaces or pockets of air.
It may be necessary to additionally apply adhesive to the back of the
tile.
COVERAGE: 20k
pack will cover approximately 6 sq metres at 3mm thin bed application.
STORAGE: Store in
a cool dry area. Shelf life should be
approximately 6 months.
LIMITATIONS: Do
not use in areas subject to permanent water immersion such as swimming pools.
PACK SIZES: Available
in 20, 10 and 5 kilos sacks in Grey and White.
HELPLINE: 24 HRS 01257
269243 TILEMASTER :
Strength Inxess
|
